Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2016 Subaru BRZ Series.HyperBlueFACTORY OEM SERVICE PROCEDURE
Fuel Sender Gauge Assembly (Fa20): Installation
- Fuel sender gauge assembly No. 2 installation
- Engage the claw and install the fuel sender gauge assembly No. 2 to the fuel sub delivery tube.
- Connect the fuel sender gauge Assembly No. 2 connector and install the harness to the clamp.
- Fuel sub sender gauge Assembly installation
- Install a new gasket to the fuel tank.CAUTION:
- Do not bend the arm of fuel sender gauge Assembly No. 2.
- Improper installation such as warpage, slip, etc. results in fuel leakage. Make sure that there is no warpage, slip, etc. in the entire circumference when installing the gasket to the fuel tank.
- Install a new gasket to the fuel tank.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.