2016 Subaru BRZ Series.HyperBlueFACTORY OEM SERVICE PROCEDURE

Camshaft Timing Oil Control Valve Assembly (Fa20): Installation

  1. Installation of camshaft timing oil control valve assembly (bank 2 exhaust side)
    1. Install the back-up ring to the camshaft timing oil control valve assembly.
    2. Apply engine oil to new O-ring, and attach it to the camshaft timing oil control valve assembly.
    3. Using 2 bolts, install the camshaft timing oil control valve assembly.

      Standard value: T=6.4N.m {65kgf.cm} {4.7ft.lbf}

    4. Connect the connector for camshaft timing oil control valve assembly.
  2. Installation of camshaft timing oil control valve assembly (bank 2 intake side)
    1. Install the back-up ring to the camshaft timing oil control valve assembly.
    2. Apply engine oil to new O-ring, and attach it to the camshaft timing oil control valve assembly.
    3. Using 2 bolts, install the camshaft timing oil control valve assembly.

      Standard value: T=6.4N.m {65kgf.cm} {4.7ft.lbf}

    4. Connect the connector for camshaft timing oil control valve assembly.
  3. Installation of air cleaner case sub-assembly (Refer to ON-VEHICLE INSPECTION )
  4. Installation of camshaft timing oil control valve assembly (bank 1 exhaust side)
    1. Install the back-up ring to the camshaft timing oil control valve assembly.
    2. Apply engine oil to new O-ring, and attach it to the camshaft timing oil control valve assembly.
    3. Using 2 bolts, install the camshaft timing oil control valve assembly.

      Standard value: T=6.4N.m {65kgf.cm} {4.7ft.lbf}

    4. Connect the connector for camshaft timing oil control valve assembly.
  5. Installation of camshaft timing oil control valve assembly (bank 1 intake side)
    1. Install the back-up ring to the camshaft timing oil control valve assembly.
    2. Apply engine oil to new O-ring, and attach it to the camshaft timing oil control valve assembly.
    3. Using 2 bolts, install the camshaft timing oil control valve assembly.

      Standard value: T=6.4N.m {65kgf.cm} {4.7ft.lbf}

    4. Connect the connector for camshaft timing oil control valve assembly.
  6. Connection of the battery ground terminal

    Standard value: T=6.0N.m {61kgf.cm} {4.4ft.lbf}

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.