Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2016 Subaru BRZ Series.HyperBlueFACTORY OEM SERVICE PROCEDURE
Function Inspection
- Initial check of brake system indicator light
- Turn the ignition switch to ON.
- Check that the ABS warning light, the brake warning light, the TRC OFF indicator light, the Vehicle stability control OFF indicator light, the Vehicle stability control SPORT indicator light and the slip indicator light illuminate and that they go off in approx. 3 seconds.NOTE: When any one of the lights does not illuminate, check the combination meter assembly.
- Brake actuator operation check
- Preparation for inspection
- Connect SSM3 to DLC3 with IG turned OFF, and start the engine.
- Turn SSM3 ON, and select [ABS/VDC System]→[Work Support]→[Function Check Sequence].
- Preparation for inspection
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.