WARNING: The following service operations include the works which may affect the SRS airbag system. Before starting work, always check the precautions for the SRS airbag system. (Refer to SRS AIRBAG SYSTEM )

Installation of steering sensor
1. Align 2 pins and 2 guides.
2. Engage 6 claws, and then attach the steering sensor to the steering roll connector.
  CAUTION: Do not rotate the steering sensor until the steering sensor is attached to the spiral cable.
Installation of steering roll connector sub-assembly (with steering sensor) (Refer to INSPECTION )
Installation of steering column cover UPR (Refer to UNIT INSPECTION )
Installation of steering column cover LWR (Refer to UNIT INSPECTION )
Installation of steering column cover support (with smart entry)
Confirmation of front tires in the straight-ahead position
Steering roll connector centering (Refer to INSPECTION )
Installation of steering wheel (Refer to INSTALLATION )
Connection of the battery ground terminal
Standard value: T=6.0N.m {61kgf.cm} {4.4ft.lbf}
Settings when removing/installing battery terminals (Refer to SETTING PROCEDURES AT PARTS REPLACEMENT AND REMOVAL/INSTALLATION )
Centering of VSC (VDC) sensor (Refer to WORK SUPPORT )
Air bag warning light check (Refer to AIRBAG WARNING LIGHT ILLUMINATION PATTERN )

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.

• Brakes feel soft, pull hard to one side, or make grinding noises.

• The engine overheats, stalls repeatedly, or misfires under load.

• You are missing required tools, torque specs, or safe lifting equipment.

• You are not confident in the next step or safety outcome.

Safety Warning

Steering Sensor: Installation

Use the Manual With the Right Hardware

When to See a Mechanic