Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

2016 Subaru BRZ Series.HyperBlueFACTORY OEM SERVICE PROCEDURE

Rear Speed Sensor: Installation

NOTE: The following procedure is for LH side. Perform the same procedures for the RH and LH side.

Installation of speed sensor RR LH
1. Install the speed sensor RR LH with 3 bolts.
  Standard value: T=7.5N.m {77kgf.cm} {5.5ft.lbf}
  
  CAUTION: Do not let foreign matter stick to the installation part and the tip of the speed sensor RR LH.
2. Attach 2 harness clamps.
  CAUTION: Do not attach the harness clamps and the harness bracket with the speed sensor RR LH wire twisted.
3. Pull the grommet from inside the vehicle and secure it.
  CAUTION:
  - Do not pull the wiring harness of the speed sensor RR LH.
  - Do not secure the drilled grommet obliquely.
4. Connect the connector.
5. Install the trunk floor mat.
Installation of rear tire
Standard value: T=120N.m {1224kgf.cm} {88.5ft.lbf}

Chapter Navigation

Return to Chapter: Rear Speed Sensor

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready Tools Compare Repair Quote Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.