Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

2016 Subaru BRZ Series.HyperBlueFACTORY OEM SERVICE PROCEDURE

Front Speed Sensor: Installation

NOTE: The following procedure is for LH side. Perform the same procedures both for the LH side and RH side, unless otherwise specified.

Installation of speed sensor FR LH
1. Install the speed sensor FR LH with bolt.
  CAUTION: Do not let foreign matter stick to the installation part and the tip of the speed sensor FR LH.
  
  Standard value: T=7.5N.m {77kgf.cm} {5.5ft.lbf}
2. Attach 6 clamps.
  CAUTION: Do not attach the speed sensor FR LH with the sensor twisted.
3. Connect the connector for the speed sensor FR LH.
Installation of front mud guard LH (Refer to INSTALLATION )
Installation of front tire
Standard value: T=120N.m {1224kgf.cm} {88.5ft.lbf}

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready Tools Compare Repair Quote Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.