Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2016 Subaru BRZ Limited, Automatic TransFACTORY OEM SERVICE PROCEDURE
How To Troubleshoot
WARNING: This page is about a different car, the 2014 Subaru BRZ. However, it is still accessible from the selected car via links, so may be relevant.
- Bring in the car
Next
- Phenomenon check
Next
- Check the diagnostic codes (Refer to CHECKING/CLEARING DIAGNOSTIC CODES
)
- DTC check
- Clear diagnostic code
- Recheck the diagnostic codes.RESULT
Result Go to Fault location confirmed A Fault location not confirmed B B: Go to Step 5
A: Go to Next Step
- List of diagnostic codes (main inspection parts) or troubleshooting for each codeRESULT
Result Go to Code output present A No code output B A: Go to Step 7
B: Go to Step 6
- Inspection with SSM3 (Refer to DATA MONITOR/ACTIVE TEST
)
- Perform the ECM data monitor and the active test.RESULT
Result Go to Fault location not confirmed A Fault location confirmed B B: Go to Step 7
A: Go to Next Step
- Perform the ECM data monitor and the active test.
- Inspect the ECM terminal voltage and circuit (Refer to ECM TERMINAL ARRANGEMENT
)
Next
- Repair faulty parts
Next
- Check the diagnostic codes (Refer to CHECKING/CLEARING DIAGNOSTIC CODES
)
Next: Completed
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
