2015 Subaru XV Crosstrek BaseFACTORY OEM SERVICE PROCEDURE

Fuel Injector: Removal

  1. Release the fuel pressure. < Ref. to RELEASING OF FUEL PRESSUREΒ , PROCEDURE, Fuel.>
  2. Disconnect the ground cable from battery.
    Fig 1: Disconnecting Ground Cable From Battery
    G08317298Courtesy of SUBARU OF AMERICA, INC.
  3. Open the fuel filler lid and remove the fuel filler cap.
    NOTE: This operation is required to release the inner pressure of the fuel tank.
  4. Remove the clip (A), and loosen the clamps (B) and (C) securing the air intake boot. (RH side only)
    Fig 2: Identifying Air Intake Boot Clamp And Clip
    G09475465Courtesy of SUBARU OF AMERICA, INC.
  5. Remove the air intake boot from the air cleaner case (rear) and throttle body, and move it to the left side wheel apron. (RH side only)
    Fig 3: Removing Air Intake Boot From Throttle Body
    G09476922Courtesy of SUBARU OF AMERICA, INC.
  6. Disconnect the connector (A) from the mass air flow and intake air temperature sensor, and remove the clip (B) which holds the mass air flow and intake air temperature sensor harness. (RH side only)
    Fig 4: Identifying Connector From Mass Air Flow And Intake Air Temperature Sensor With Clip
    G08315338Courtesy of SUBARU OF AMERICA, INC.
  7. Remove the air cleaner case (rear). (RH side only)
    Fig 5: Locating Air Intake Case (Rear) Clamp - RH Side
    G08315339Courtesy of SUBARU OF AMERICA, INC.
  8. Remove the intake manifold protector.
    • RH side
      Fig 6: Locating Intake Manifold Protector Mounting Bolts (RH Side)
      G08315340Courtesy of SUBARU OF AMERICA, INC.
    • LH side
      Fig 7: Locating Intake Manifold Protector Mounting Bolts (LH Side)
      G08315343Courtesy of SUBARU OF AMERICA, INC.
  9. Disconnect the connectors (A) from fuel injector.
  10. Disconnect the quick connector (B) of the fuel delivery pipe from the fuel pipe.
    CAUTION:
    • Be careful not to spill fuel.
    • Catch the fuel from the pipes using a container or cloth.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.