2015 Subaru WRX BaseFACTORY OEM SERVICE PROCEDURE

Except For STI Model

  1. Temporarily install the crankshaft position sensor plate and flywheel.
    NOTE: Align the knock pin hole of the crankshaft position sensor plate to the knock pin of the crankshaft to secure the knock pin.
  2. Attach the ST.

    ST 498497100 CRANKSHAFT STOPPER

    Fig 1: Aligning Knock Pin Hole Of Crankshaft Position Sensor Plate
    G07680095Courtesy of SUBARU OF AMERICA, INC.
  3. Tighten the flywheel mounting bolts in two stages.
    1. Tighten the flywheel attachment bolts.

      Tightening torque: 

      30 N.m (3.1 kgf-m, 22.1 ft-lb) 

      Fig 2: Flywheel Mounting Bolts Tightening Sequence
      G07680096Courtesy of SUBARU OF AMERICA, INC.
    2. While checking the tightening angle with the angle gauge, further tighten the flywheel mounting bolts.

      Tightening angle: 

      30° - 35° 

  4. Install the clutch disc and cover. <Ref. to INSTALLATION , Clutch Disc and Cover.>
  5. Install the transmission assembly. <Ref. to INSTALLATION , Manual Transmission Assembly.>
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.