2015 Subaru WRX BaseFACTORY OEM SERVICE PROCEDURE

MT Gear Select Cable: Adjustment

NOTE: Two persons are required to perform the MT gear select cable adjustment. (Only the step 7) requires two workers.)
  1. Loosen the detent bolt of the MT gear shift lever. <Ref. to ADJUSTMENTΒ , MT Gear Shift Lever.>
  2. Move the shift lever to the 6th.
  3. Remove the cable cover plate.
    Fig 1: Locating Cable Cover Plate Bolts
    G10267862Courtesy of SUBARU OF AMERICA, INC.
  4. Disconnect the MT gear select cable.
    NOTE: Push the MT gear select cable in the direction of arrow, and remove it.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.