Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2015 Subaru WRX BaseFACTORY OEM SERVICE PROCEDURE
Stop Light Switch: Installation
WARNING: This page is about a different car, the 2015 Subaru Outback and 2015 Subaru Legacy. However, it is still accessible from the selected car via links, so may be relevant.
- Install the stop light switch onto the bracket with screws and position it with the nut.
- Adjust the stop light switch position, and then tighten the nut. <Ref. to
ADJUSTMENT , Stop Light Switch.>
Tightening torque:
8 N.m (0.8 kgf-m, 5.9 ft-lb)
- Install the panel - knee guard.
Tightening torque:
7 N.m (0.7 kgf-m, 5.2 ft-lb)
- Install the cover assembly - instrument panel LWR driver.
- Connect the ground terminal to battery sensor. <Ref. to BATTERY , NOTE, Repair Contents.>
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.