WARNING: This page is about a different car, the 2015 Subaru Outback and 2015 Subaru Legacy. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION:

Before handling the airbag module, refer to "CAUTION" of "General Description" in "AIRBAG SYSTEM". <Ref. to CAUTION , General Description.>
Do not allow harness and connectors to interfere or get tangled up with other parts.
If the steering wheel has been removed, make sure that the steering roll connector is not turned from the original position.
If the steering wheel and steering angle sensor (steering roll connector) are removed, perform "VDC sensor midpoint setting mode" of the VDC. <Ref. to VDC SENSOR MIDPOINT SETTING MODE , ADJUSTMENT, VDC Control Module and Hydraulic Control Unit (VDCCM&H/U).>
Securely install the switch. Improper insertion of the pin or claw of the switch may cause improper installation.

Install the cruise control command switch assembly.
Align the center position of the steering roll connector. <Ref. to ADJUSTMENT , Roll Connector.>
Install the steering wheel.
Tightening torque:

39 N.m (4.0 kgf-m, 28.8 ft-lb)

Clearance:

Between cover assembly - column and steering wheel: 4 - 6 mm (0.16 - 0.24 in)
Install the driver's airbag module. <Ref. to INSTALLATION , Driver's Airbag Module.>
Connect the ground terminal to battery sensor. <Ref. to BATTERY , NOTE, Repair Contents.>

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.

• Brakes feel soft, pull hard to one side, or make grinding noises.

• The engine overheats, stalls repeatedly, or misfires under load.

• You are missing required tools, torque specs, or safe lifting equipment.

• You are not confident in the next step or safety outcome.

Safety Warning

Cruise Control Command Switch: Installation

Use the Manual With the Right Hardware

When to See a Mechanic