2015 Subaru Outback 3.6R LimitedFACTORY OEM SERVICE PROCEDURE

Crankshaft Position Sensor: Removal

  1. Remove the collector cover.
    1. Carefully pull up the rear of collector cover at two positions (A).
    2. Carefully pull up the front of collector cover at two positions (B) while moving it forward.
      Fig 1: Locating Rear And Front Collector Cover Positions
      G10263528Courtesy of SUBARU OF AMERICA, INC.
  2. Disconnect the ground terminal from battery sensor. <Ref. to BATTERY , NOTE, Repair Contents.>
  3. Loosen the clamp (A) securing the air intake boot.
  4. Remove the bolt (B) securing the air intake boot to the collector cover bracket.
    Fig 2: Identifying Air Intake Boot Clamp And Bolts
    G10263529Courtesy of SUBARU OF AMERICA, INC.
  5. Remove the air intake boot from the throttle body and the air cleaner case (rear), and move it to the left side wheel apron.
    Fig 3: Identifying Throttle Body Air Intake Boot
    G10263530Courtesy of SUBARU OF AMERICA, INC.
  6. Disconnect the connector (A) from the throttle body, and remove the throttle body from the intake manifold.
    NOTE: Do not disconnect the preheater hose.
Chapter Navigation
Return to Chapter: Crankshaft Position Sensor
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.