Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

2015 Subaru Outback 3.6R LimitedFACTORY OEM SERVICE PROCEDURE

Intake Side

Remove the collector cover.
1. Carefully pull up the rear of collector cover at two positions (A).
2. Carefully pull up the front of collector cover at two positions (B) while moving it forward.
  
  Fig 1: Locating Rear And Front Collector Cover Positions
  Courtesy of SUBARU OF AMERICA, INC.
Disconnect the ground terminal from battery sensor. <Ref. to BATTERY , NOTE, Repair Contents.>
Remove the fuel injector. <Ref. to REMOVAL , Fuel Injector.>
Disconnect the connector (A) from the camshaft position sensor, and remove the camshaft position sensor.
- RH side
  
  Fig 2: Locating Camshaft Position Sensor (RH Side)
  Courtesy of SUBARU OF AMERICA, INC.
- LH side
  
  Fig 3: Locating Camshaft Position Sensor (LH Side)
  Courtesy of SUBARU OF AMERICA, INC.

Chapter Navigation

Return to Chapter: Removal

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready Tools Compare Repair Quote Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.