2015 Subaru BRZ Limited, Automatic TransFACTORY OEM SERVICE PROCEDURE

Unit Inspection

  1. Inspection of intake air flow meter sub-assembly
    1. Use a working lamp, visually check the platinum filament (heater) portion of the intake air flow meter sub-assembly for foreign matter.
      Fig 1: Checking Platinum Filament (Heater) Portion Of Intake Air Flow Meter Sub-Assembly
      G10213029Courtesy of SUBARU OF AMERICA, INC.

      Criteria: No foreign matter

      NOTE: If there is a foreign matter on the platinum filament (heater), replace the intake air flow meter sub-assembly.
    2. Inspection of intake temperature sensor resistance
      1. Measure the resistance between the terminals.

        Resistance

        Inspection terminals Inspection conditions Standard value
        1 - 2 -20°C {-4°F} 13.6 to 18.4 kΩ
        20°C {68°F} 2.21 to 2.69 kΩ
        60°C {140°F} 0.49 to 0.67 kΩ
        Fig 2: Intake Air Flow Meter Sub-Assembly Connector Terminal Identification
        G10213030Courtesy of SUBARU OF AMERICA, INC.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.