Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Differential Case Assembly
- Install the washer, differential bevel gear and differential bevel pinion in the differential case (RH). Insert the pinion shaft.
- Attach the straight pin in the reverse direction.
- Install the washer and differential bevel gear to differential case (LH). Put the differential case (LH) on the differential case (RH), and assemble the two differential cases.
- Install the hypoid driven gear and secure by tightening the bolt.
Tightening torque:
70 N.m (7.1 kgf-m, 51.6 ft-lb)
- Measurement of backlash (Selection of washer)
- Install the SUBARU genuine axle shaft to differential case.
Part No. 38415AA070 Axle shaft
- Measure the gear backlash with ST1 and ST2. Insert ST2 from the access window of the differential case.NOTE:
- Measure the backlash by applying a differential bevel pinion tooth between two differential bevel gear teeth.
- When measuring, fix the differential bevel pinion gear in place with a screwdriver covered with cloth, or a similar tool.
Specification:
0.13 - 0.18 mm (0.0051 - 0.0071 in)
ST1 498247001 MAGNET BASE
ST2 498247100 DIAL GAUGE
- If the backlash is not within specification, select a washer from the table below.
Washer Part No. Thickness mm (in) 803038021 0.95 (0.037) 803038022 1.00 (0.039) 803038023 1.05 (0.041) - Install the SUBARU genuine axle shaft to differential case.
- Using the ST, install the taper roller bearing.
ST 398487700 DRIFT
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
No obligation. See pricing before you book.