2014 Subaru TribecaFACTORY OEM SERVICE PROCEDURE

Occupant Detection System

OCCUPANT DETECTION DIAGNOSTIC TROUBLE CODE (DTC) LIST

DTC Description Reference
2A System calibration (Rezeroing) was not completed normally. Refer to DTC 2A ODS CALIBRATION ERROR , Diagnostic Procedure with Diagnostic Trouble Code (DTC).
2B
  • Wrong airbag control module is installed.
  • Wrong occupant detection system is installed.
  • Occupant detection system is faulty.
 Refer to DTC 2B ODS SYSTEM WRONG PARTS , Diagnostic Procedure with Diagnostic Trouble Code (DTC).
2C
  • Passenger's seat belt tension sensor is faulty.
  • Airbag rear harness circuit is open or shorted.
  • Occupant detection system is faulty.
  • Occupant detection harness is faulty.
 Refer to DTC 2C BELT TENSION SENSOR FAILURE , Diagnostic Procedure with Diagnostic Trouble Code (DTC).
27
  • Occupant detection control module and airbag control module communication is faulty.
  • Airbag rear harness circuit is open, shorted, shorted to ground or shorted to power supply.
  • Occupant detection harness is faulty.
  • Occupant detection system is faulty.
  • Airbag control module is faulty.
 Refer to DTC 27 ODS COMMUNICATION ERROR , Diagnostic Procedure with Diagnostic Trouble Code (DTC).
29
  • Occupant detection sensor is faulty.
  • Occupant detection control module is faulty.
  • Occupant detection harness is faulty.
  • Fuse No. 25 (in joint box) is blown.
 Refer to DTC 29 ODS FAILURE , Diagnostic Procedure with Diagnostic Trouble Code (DTC).
37
  • Passenger's buckle switch circuit is open, shorted or shorted to ground.
  • Occupant detection system is faulty.
  • Occupant detection harness is faulty.
 Refer to DTC 37 BUCKLE SWITCH RH FAILURE , Diagnostic Procedure with Diagnostic Trouble Code (DTC).
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.