2014 Subaru TribecaFACTORY OEM SERVICE PROCEDURE

Injector Control (Injection Stop Mode)

CAUTION: After executing the system operation check mode, execute the Clear Memory Mode. Refer to OPERATION , Clear Memory Mode.
  1. On «System Operation Check Mode» display, select {Injector Control}.
  2. On «Injector Control» display, select {Injection Stop Mode}.
  3. On «Injection Stop Mode» display, select the fuel injector to be stopped.
  4. On «Start the Engine» display, start the engine and click the [OK] button.
  5. On «Fuel Injector #» display, click the [Execution] button and execute the injection stop mode.
  6. Click the [Cancel] button to stop the injection stop mode.
  7. Click the [F12Exit] button to return the «Injection Stop Mode» display screen.
  8. On «Injection Stop Mode» display, click the [Return] button to end the «Injection Stop Mode». The screen will return to the «Injector Control» screen.
NOTE: For detailed operation procedures, refer to " Subaru Select Monitor".
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.