Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2014 Subaru TribecaFACTORY OEM SERVICE PROCEDURE
Malfunction Indicator Light Does Not Go Off: Trouble Symptom
Although malfunction indicator light comes on when the engine runs, DTC is not shown on the Subaru Select Monitor or generic scan tool display.
| Step | Check | Yes | No |
|---|---|---|---|
| 1 CHECK DTC. | Is DTC of engine or LAN system displayed? Refer to OPERATION , Read Diagnostic Trouble Code (DTC). | Check the appropriate DTC using the "List of Diagnostic Trouble Code (DTC)". Refer to LIST OF DIAGNOSTIC TROUBLE CODE (DTC) . > Refer to LIST OF DIAGNOSTIC TROUBLE CODE (DTC) |
(DTC). > Go to step 2 |
| 2 CHECK COMBINATION METER. Perform the self-diagnosis for combination meter system. Refer to SELF-DIAGNOSIS , INSPECTION, Combination Meter System. | Does the malfunction indicator light illuminate and go off normally? | Replace the ECM. Refer to ENGINE CONTROL MODULE (ECM) | Replace the meter case assembly of combination meter. Refer to COMBINATION METER |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
