2014 Subaru TribecaFACTORY OEM SERVICE PROCEDURE

SUBARU Select Monitor (OBD Mode)

  1. On the «Main Menu», select {Each System Check}.
  2. On the «System Selection Menu», select {Engine Control System}.
  3. Select [OK] after the information of engine type has been displayed.
  4. On the «Engine Diagnosis» display screen, select the {OBD System}.
  5. On the «OBD Menu» display screen, select the {Clear Diagnostic Code}.
  6. When the "Clear Diagnostic Code?" is shown on the screen, click the [Yes] button.
  7. When "Done" and "Turn ignition switch to OFF" are shown on the display screen, turn the ignition switch to OFF.
NOTE:
  • Initial diagnosis of electronic throttle control is performed after memory clearance. Therefore, start the engine after 10 seconds or more have passed since turning the ignition switch to ON.
  • For detailed operation procedure, refer to " Subaru Select Monitor".
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.