Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

2014 Subaru TribecaFACTORY OEM SERVICE PROCEDURE

Fuel Filler Pipe: Installation

Open the fuel filler lid.
Set the fuel saucer (A) with gasket (C), and insert the fuel filler pipe into hole from the inner side of apron.
Align the holes in fuel filler pipe neck and set the cup (B), and tighten the bolts.
NOTE: If the edges of gasket are folded toward inside, straighten it with a flat tip screwdriver.

Tightening torque:

4.5 N.m (0.5 kgf-m, 3.3 ft-lb)

Fig 1: Identifying Fuel Saucer, Gasket And Cup
Courtesy of SUBARU OF AMERICA, INC.
Correctly insert the fuel filler hose to specified position, and then tighten the clamp.
Tightening torque:

2.5 N.m (0.3 kgf-m, 1.8 ft-lb)

Fig 2: Identifying Fuel Filler Hose
Courtesy of SUBARU OF AMERICA, INC.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready Tools Compare Repair Quote Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.