Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2014 Subaru TribecaFACTORY OEM SERVICE PROCEDURE
VDC Sequence Control With SUBARU Select Monitor
NOTE:
In the event of any trouble, sequence control will not operate.
- Connect the Subaru Select Monitor to data link connector under the driver's side instrument panel lower cover.
- Turn the ignition switch to ON.
- Run the "PC application for Subaru Select Monitor".
- Set the Subaru Select Monitor to "Brake Control System" mode.
- When the "VDC Inspection Mode" is selected from the "Function check sequence" menu, the "VDC sequence control" will start.
- "Press "OK"" will be displayed. Press the [OK] key.
- Operation points will be displayed on Subaru Select Monitor.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
