Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2014 Subaru TribecaFACTORY OEM SERVICE PROCEDURE
Front ABS Wheel Speed Sensor: Removal
- Disconnect the ground cable from the battery.
- Disconnect the ABS wheel speed sensor connector in the engine compartment.
- Remove the sensor harness from the clip.
- Remove the clip which secures the sensor harness to the front strut.
- Remove the front ABS wheel speed sensor from housing.CAUTION:
- Be careful not to damage the sensor.
- Do not apply excessive force to the sensor harness.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.