Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2014 Subaru TribecaFACTORY OEM SERVICE PROCEDURE
Freeze Frame Data
NOTE:
- Data stored at the time of trouble occurrence is shown on display.
- Each time a trouble occurs, the latest information is stored in the freeze frame data in memory.
| Display | Contents to be displayed |
|---|---|
| IG counter | Number of ignition switch ON is displayed. |
| Trouble Code | Recorded trouble code is displayed. |
| FR Wheel Speed | Wheel speed detected by front ABS wheel speed sensor RH is displayed in km/h or MPH. |
| FL Wheel Speed | Wheel speed detected by front ABS wheel speed sensor LH is displayed in km/h or MPH. |
| RR Wheel Speed | Wheel speed detected by rear ABS wheel speed sensor RH is displayed in km/h or MPH. |
| RL Wheel Speed | Wheel speed detected by rear ABS wheel speed sensor LH is displayed in km/h or MPH. |
| Vehicle Speed | Vehicle speed calculated by VDC control module is displayed. |
| G Sensor First Axis (GL1) | The sensor value for a 45° angle crossed 2 axis G sensor is displayed. |
| G Sensor Sec Axis (GL2) | |
| Yaw Rate Sensor Output | Vehicle angular speed detected by yaw rate sensor is displayed. |
| ABS_CM Power Voltage | Voltage supplied to VDC control module is displayed. |
| Steer Angle Sensor Op | Steering angle detected by steering angle sensor is displayed. |
| Pressure Sensor Output | Brake fluid pressure detected by pressure sensor is displayed. |
| Engine Speed | Engine speed on malfunction occurrence is displayed. |
| Accel. Opening Angle | Acceleration opening is displayed. |
| Gear Position | Gear position on malfunction occurrence is displayed. |
| Steering Angle Sens Code | Recorded trouble code of steering angle sensor is displayed. |
| ABS Control Flag | ABS control condition is displayed. |
| EBD Control Flag | EBD control condition is displayed. |
| Brake Switch | Brake ON/OFF is displayed. |
| TCS Control Flag | TCS control condition is displayed. |
| VDC Control Flag | VDC control condition is displayed. |
| E/G Control Stop Flag | Engine control command signal is displayed. |
| Steering angle flag | Whether the absolute angle was determined is displayed. |
| OFF SW Signal | Operation condition of TCS OFF switch is displayed. |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.