Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2014 Subaru TribecaFACTORY OEM SERVICE PROCEDURE
Read Diagnostic Trouble Code (DTC): Operation
- On «Main Menu» display, select {Each System Check}.
- On «System Selection Menu» display, select {Brake Control System}.
- Click the [OK] button after {VDC} is displayed.
- On «Brake Control Diagnosis» display, select {Diagnostic Code(s) Display}.
- Record the DTC and data.NOTE:
- For detailed operation procedures, refer to "Subaru Select Monitor" operating information.
- For details concerning DTCs, refer to "List of Diagnostic Trouble Code (DTC)". < Refer to LIST OF DIAGNOSTIC TROUBLE CODE (DTC) . >
- Up to 3 DTCs are displayed in the order of detection.
Display Contents to be displayed Latest The latest DTC is displayed on Subaru Select Monitor display screen. (Old) The latest DTC from the history of previous problems is displayed on Subaru Select Monitor display screen. (Older) The second latest DTC from the history of previous problems is displayed on the Subaru Select Monitor display screen.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
