Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2014 Subaru TribecaFACTORY OEM SERVICE PROCEDURE
Fuel Tank: Installation
- Install the fuel tank to the vehicle.WARNING: A helper is required to perform this work.
- Lift the fuel tank with the transmission jack.
- Mount the fuel tank to the vehicle with a jack.
- Install the fuel tank band that holds the fuel tank.
Tightening torque:Β
33 N.m (3.4 kgf-m, 24.3 ft-lb)Β
- Connect purge hose (A), connector (B) and fuel filler hose (C).
Tightening torque:Β
2.5 N.m (0.3 kgf-m, 1.8 ft-lb)Β
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
