Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUBARU2014OUTBACK 2.5I, STANDARD TRANSREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT VARIANT/TRIMSECTION 8 (AUTOMATIC TRANSAXLE)TRANSMISSION CONTROL MODULE (TCM)INSTALLATION
2014 Subaru Outback 2.5i, Standard Trans
Transmission Control Module (TCM): Installation
2014 Subaru Outback 2.5i, Standard TransSECTION Installation
WARNING: This page is about a different variant/trim than selected.
- Install the TCM to the bracket.CAUTION: Do not remove the TCM after installed to the bracket, or the bracket and TCM may be damaged. If installed by mistake, the part must be replaced with a new part.
- Install the TCM.
Tightening torque:
7.5 N.m (0.8 kgf-m, 5.5 ft-lb)
- Connect the connector to TCM.
- Install the instrument panel lower cover. Refer to INSTALLATION .
- Perform Clear Memory 2 operation. Refer to CLEAR MEMORY MODE .
- Perform the diagnosis again. Refer to LEARNING CONTROL .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.