Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUBARU2014OUTBACK 2.5I, STANDARD TRANSREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTANTI-THEFT SYSTEMSANTI-THEFT SYSTEM - SECURITY AND LOCKSKEYLESS ENTRY SYSTEMELECTRICAL SPECIFICATIONKEYLESS ENTRY CONTROL MODULE
2014 Subaru Outback 2.5i, Standard Trans
Keyless Entry Control Module
2014 Subaru Outback 2.5i, Standard TransSECTION Keyless Entry Control Module
- Model without tire pressure monitoring system
| Terminal No. | Item | Measuring condition | Standard |
|---|---|---|---|
| 3 (U-ART com.) | - | Cannot be measured | - |
| 4 (+B) ↔ Chassis ground | Voltage | Always | 10 - 14 V |
| 7 (GND) ↔ chassis ground | Resistance | Always | Less than 1 Ω |
- Model with tire pressure monitoring system
| Terminal No. | Item | Measuring condition | Standard |
|---|---|---|---|
| 2 ↔ Chassis ground | Voltage | Tire pressure warning light: Not illuminated → Illuminated | 0 V → 10 - 14 V |
| 3 ↔ Chassis ground | Waveform | Speedometer | Pulse generation |
| 4 (IG) ↔ Chassis ground | Resistance | IG OFF → ON | 0 V → 10 - 14 V |
| 5 (GND) ↔ chassis ground | Resistance | Always | Less than 1 Ω |
| 6 (+B) ↔ Chassis ground | Voltage | Always | 10 - 14 V |
| 11 (U-ART com.) | - | Cannot be measured | - |
| 12 (SSM communication) | - | Cannot be measured | - |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.