SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUBARU2014LEGACY 2.5I, AUTOMATIC CVT TRANSREPAIR AND DIAGNOSIS (SINGLE PAGE)BRAKESTRACTION CONTROLVEHICLE DYNAMICS CONTROL SYSTEM - MECHANISM & FUNCTIONVEHICLE DYNAMICS CONTROL (VDC) SYSTEMSYSTEM COMPONENTS AND FUNCTIONS
2014 Subaru Legacy 2.5i, Automatic CVT Trans

System Components And Functions

2014 Subaru Legacy 2.5i, Automatic CVT TransSECTION System Components And Functions
VDCCM
  • Determines the vehicle's running condition from various sensor signals and, based on the result, controls the vehicle dynamics control (VDC) hydraulic unit, ABS and TCS as required.
  • Performs CAN communication with the engine control module, automatic transmission control module and the steering angle senso.
  • Causes the system to stop and the warning light to illuminate if a fault occurs in a circuit of the electrical system. Stores the code that indicates the location of the fault.
Vehicle dynamics control (VDC) hydraulic unit (VDC H/U) Actuates the pump motor in response to a command from the VDCCM and changes fluid passages using solenoid valves to control the hydraulic pressures applied to the wheel cylinders.
Steering angle sensor Detects the steering direction and angle when the steering wheel is operated by the driver, and outputs signals corresponding to them to the CAN line.
Yaw-rate and lateral G sensor Detects the yaw-rate and lateral G of the vehicle and outputs it to the VDCCM.
Pressure sensor Detects the hydraulic pressure resulting from driver's brake pedal operation and outputs it to the VDCCM.
ABS wheel speed sensor Detects the speed of each wheel and outputs it to the VDCCM.
Engine control module (ECM) Controls the engine output in response to commands from the VDCCM. Further, it transmits current engine output and engine speed signals etc. to the VDCCM.
Automatic transmission control module Controls the transfer clutch in response to commands from the VDCCM during vehicle dynamics control (VDC) control, ABS control or TCS control so that torque is distributed optimally between the front and rear axles.
ABS warning light Alerts the driver to an ABS fault.
Vehicle dynamics control (VDC) warning light and vehicle dynamics control (VDC) OFF indicator light
  • Alerts the driver to a vehicle dynamics control (VDC) or TCS fault.
  • Illuminates to tell the driver that the vehicle dynamics control (VDC) and TCS are inactive. (when system is not failed)
Brake warning light Alerts the driver to an EBD fault. This warning light is also used for parking brake warning and brake fluid level warning.
Vehicle dynamics control (VDC) operation indicator light Blinks when the vehicle dynamics control (VDC) is operating or lights steadily when the TCS is operating.
Vehicle dynamics control (VDC) OFF switch
  • Allows the driver to temporarily disengage the vehicle dynamics control (VDC).
  • In "temporarily disengaged" status, the vehicle dynamics control (VDC) OFF indicator light illuminates.
NOTE: CAN (Controller Area Network) communication refers to bidirectional multiplex high-speed communication.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.