Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2014 Subaru BRZ PremiumFACTORY OEM SERVICE PROCEDURE
Test drive
Perform test drive to check if the DTC recurs.
- Connect the SSM3 to the DLC3.
- Turn the ignition switch to ON.
- Turn on the SSM3.
- Follow the SSM3 on-screen instructions to clear the DTCs. (Refer to CHECKING/CLEARING DTC )
- Turn the ignition switch to OFF, and wait for 30 seconds.
- Turn the ignition switch to ON.
- Turn on the SSM3.
- Check that the engine coolant temperature is 30Β°C {86Β°F} or less.
- Start the engine and perform driving test as follows.WARNING: When performing this driving test, always observe the applicable traffic laws such as the speed limit.
- Idle the engine for 10 seconds or more. (A)
- Drive at 80 km/h {50 MPH} or more for 8 minutes or more. (B)
- Stop the vehicle and run the engine on idling for 30 seconds or more. (C)
- Drive at 80 km/h {50 MPH} or more for 30 seconds or more. (D)
- Stop the vehicle and run the engine on idling for 30 seconds or more. (E)
- Drive at 80 km/h {50 MPH} or more for 30 seconds or more. (F)
- Stop the vehicle and run the engine on idling for 30 seconds or more. (G)
- Follow the SSM3 on-screen instructions to check the DTC. (Refer to CHECKING/CLEARING DTC )
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
