Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2014 Subaru BRZ PremiumFACTORY OEM SERVICE PROCEDURE
Fuel Pump Control Computer (FA20): Installation
- Fuel pump control computer assembly installation
- Engage the bracket of fuel pump control computer assembly to the body mounting hole and pass the stud bolt through the body hole.
- Install the fuel pump control computer assembly with the nut.
Standard value: T=5.0N.m {51kgf.cm} {3.7ft.lbf}
CAUTION: If impact is applied to the fuel pump control computer assembly, do not reuse it. - Connect the fuel pump control computer connector.
- Installation of luggage compartment trim side cover RH (Refer to INSTALLATION )
- Installation of luggage compartment trim cover INN RH (Refer to INSTALLATION )
- Separate type rear seat cushion assembly installation (Refer to INSTALLATION )
- Front door scuff plate RH installation (Refer to INSTALLATION )
- Installation of front door opening trim weather strip RH (Refer to POWER WINDOW SYSTEM )
- Battery ground terminal installation
Standard value: T=6.0N.m {61kgf.cm} {4.4ft.lbf}
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.