Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2014 Subaru BRZ PremiumFACTORY OEM SERVICE PROCEDURE
Unit Inspection
- Fuel pump check
- Resistance check
- Measure the resistance between the terminals.
Inspection terminals Inspection conditions Standard value 3 - 4 20Β°C {68Β°F} 0.2 to 3.0 Ξ© - Operation check
- Apply the battery voltage between the terminals and check the motor operation.CAUTION:
- Drain the fuel completely.
- Perform the check in a short period of time (10 sec. or less).
- Place the fuel pump as far apart as possible from the battery.
- Apply the battery voltage between the terminals and check the motor operation.
- Resistance check
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.