Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2013 Subaru TribecaFACTORY OEM SERVICE PROCEDURE
Read Current Data
- On «Main Menu» display, select {Each System Check}.
- On «System Selection Menu» display, select {Brake Control System}.
- Click the [OK] button after {VDC} is displayed.
- On «Brake Control Diagnosis» display, select {Current Data Display & Save}.
- On «Data Display Menu» display, select the data display method.
- Using the scroll key, scroll the display screen up or down until necessary data is shown.
- A list of the support data is shown in the following table.
Display Contents to be displayed Unit of measure FR Wheel Speed Wheel speed detected by front ABS wheel speed sensor RH is displayed. km/h or MPH FL Wheel Speed Wheel speed detected by front ABS wheel speed sensor LH is displayed. km/h or MPH RR Wheel Speed Wheel speed detected by rear ABS wheel speed sensor RH is displayed. km/h or MPH RL Wheel Speed Wheel speed detected by rear ABS wheel speed sensor LH is displayed. km/h or MPH Longitudinal G Sensor Vehicle longitudinal acceleration detected by G sensor is displayed. m/s2 Lateral G Sensor Vehicle lateral acceleration detected by G sensor is displayed. m/s2 IG power supply voltage Voltage supplied to VDCCM&H/U is displayed. V Steering Angle Sensor Steering angle detected by steering angle sensor is displayed. deg Yaw Rate Sensor Vehicle angular speed detected by yaw rate sensor is displayed. deg/s Pressure Sensor Brake fluid pressure detected by pressure sensor is displayed. bar ABS Control Flag ABS control condition is displayed. ON or OFF EBD Control Flag EBD control condition is displayed. ON or OFF Brake Switch Brake ON/OFF is displayed. ON or OFF ABS Warning Light ON operation of the ABS warning light is displayed. ON or OFF EBD Warning Light ON operation of the EBD warning light is displayed. ON or OFF Motor Relay Signal Motor relay operation signal is displayed. ON or OFF Motor Relay Monitor Motor relay monitor signal is displayed. ON or OFF TCS Control Flag TCS control condition is displayed. ON or OFF Valve Relay Signal Valve relay operation signal is displayed. ON or OFF VDC Control Flag VDC control condition is displayed. ON or OFF VDC Warning Light ON operation of the VDC warning light is displayed. ON or OFF OFF Lamp ON/OFF condition of TCS OFF indicator light is displayed. ON or OFF E/G Control Stop Flag Engine control command signal is displayed. 1 or 0 OFF SW Signal Operation condition of TCS OFF switch is displayed. ON or OFF Fail Safe Relay Signal Motor fail safe relay operation signal is displayed. ON or OFF NOTE: For details concerning the operation procedure, refer to "PC application help for Subaru Select Monitor".
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
Comes to youSame-day available12-month warranty
Get a Free QuoteNo obligation. See pricing before you book.