Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2013 Subaru Outback RFACTORY OEM SERVICE PROCEDURE
Transmission Control Device: Removal
- Remove the transmission assembly from the vehicle. Refer to REMOVAL .
- Pull out the torque converter assembly. Refer to REMOVAL .
- Lift up the lever on the rear side of transmission harness connector, and then disconnect it from the stay.
- Wrap vinyl tape around the nipple attached to the air breather hose.
- Remove the transmission hanger COMPL.
- Remove the control valve body assembly. Refer to REMOVAL .
- Pull out the straight pin of manual plate.
- Remove the bolts securing range select lever, and then remove the select lever, manual plate and parking rod.NOTE: Be careful not to damage the lips of press-fitted oil seal in the case.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
Comes to youSame-day available12-month warranty
Get a Free QuoteNo obligation. See pricing before you book.