Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Transmission Control Device: Installation
- Install the parking support.
Tightening torque:
25 N.m (2.5 kgf-m, 18.4 ft-lb)
- Install the extension case. Refer to INSTALLATION .
- Install the manual valve.
- Install the shifter arm shaft and bolt.NOTE: Do not damage the lip of oil seal press-fitted in the case.
Tightening torque:
7 N.m (0.7 kgf-m, 5.2 ft-lb)
- Install the parking rod to the manual plate.
- Insert the parking rod into the transmission case, and install the shift connecting rod of the manual valve to the manual plate.
- Install the manual plate to the shifter arm shaft.
- Install the detent spring to the transmission case.
Tightening torque:
7 N.m (0.7 kgf-m, 5.2 ft-lb)
- Install the spring pin.NOTE: Use new spring pin.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
No obligation. See pricing before you book.