Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2013 Subaru Outback Base, Standard TransFACTORY OEM SERVICE PROCEDURE
MT Gear Shift Lever: Adjustment
NOTE:
Adjust the detent when the following items have been replaced.
- MT gear shift lever
- MT gear select cable
- Manual transmission assembly
- Remove the shift knob.
- Remove the console front cover assembly. Refer to REMOVAL .
- Place the shift lever in neutral position.
- Loosen the detent bolt.
- Move the detent up and down and align the detent pin to the groove. Make sure that the detent pin is fitted in the groove and a clicking sound is heard.
- Pull up the slider, select the shift lever to the reverse direction, and make sure it returns to the neutral position after releasing hands.
- Tighten the detent bolt.NOTE: When tightening the bolt, hold the shift lever by hand so that the detent pin does not come out from the groove.
Tightening torque:
7.5 N.m (0.8 kgf-m, 5.5 ft-lb)
- Move the shift lever to the neutral position, and check that the play in the select direction above the shift knob is within the reference standard. If it is not within the reference standard, repeat adjustment procedures from the beginning.
Play in neutral position:
Reference standard
1.5 mm (0.059 in) or less
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
