Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Select Lever: Installation
- Set the select lever assembly to the vehicle body.
- Tighten the four mounting bolts to attach the select lever assembly to the vehicle body.
Tightening torque:
18 N.m (1.8 kgf-m, 13.3 ft-lb)
- Connect the harness connector.
- Install the harness clip to the select lever assembly.
- Shift the select lever to "N" range.
- Install the console box and the console front cover assembly. Refer to INSTALLATION .
- Accessing from the button side of the grip, attach the clamp grip pin.
- Install the cover grip AT securely.NOTE: After installation, check that the cover grip AT cannot be detached.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
No obligation. See pricing before you book.