Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

2013 Subaru Outback Base, Standard TransFACTORY OEM SERVICE PROCEDURE

Special Tool

TOOL NUMBER	DESCRIPTION	REMARKS
1B022XU0	SUBARU SELECT MONITOR III KIT	Used for troubleshooting the electrical system.
99099AJ000	ENGINE HANGER	Used for holding and balancing the engine unit when removing and installing the MT gear select cable. Used together with CHAIN BALANCER (99099AJ010).
99099AJ010	CHAIN BALANCER	Used for holding and balancing the engine unit when removing and installing the MT gear select cable. Used together with ENGINE HANGER (99099AJ000).
41099AJ130	SPECIAL TOOL FB	Used for holding and balancing the engine unit when removing and installing the MT gear select cable.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready Tools Compare Repair Quote Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.