2013 Subaru Outback Base, Standard TransFACTORY OEM SERVICE PROCEDURE

Rearview Camera System: Inspection

WARNING: This page is about a different car, the 2013 Subaru Forester. However, it is still accessible from the selected car via links, so may be relevant.
  1. Park the vehicle at the level place where there are enough area at the rear of the vehicle.
  2. Attach the tape as the target point for standard at the floor rearward of the vehicle as shown in the figure below.
    NOTE:

    Standard tape width is about 30 - 50 mm (1.18 - 1.97 in) and brilliant color shall be used.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.