2013 Subaru Outback Base, Standard TransFACTORY OEM SERVICE PROCEDURE

Check Each Connection (Display Audio)

WARNING: This page is about a different car, the 2013 Subaru Forester. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn the ignition switch to ON, and then while pressing the buttons (a) and (b), press and hold the button (c) for 3 seconds or more.
    Fig 1: Identifying Connection Buttons
    G07681343Courtesy of SUBARU OF AMERICA, INC.
  2. The display will switch to the Line Diag screen.
    Fig 2: Identifying Line Diag Screen
    G08566352Courtesy of SUBARU OF AMERICA, INC.
    • CHECK MICROPHONE 

      Check that "OK" is displayed in MIC.

      OK: Normal.

      NG: Abnormal. Check the signal line connector. If there are no problems, the unit could be faulty.

    • CHECK REARVIEW CAMERA 

      Check that "OK" is displayed in Rr_CAM.

      OK: Normal.

      NG: Abnormal. Check the signal line connector. If there are no problems, the unit could be faulty.

    • CHECK AUX 

      Check that "OK" is displayed in AUX.

      OK: Normal.

      NG: Abnormal. Check the signal line connector. If there are no problems, the unit could be faulty.

    • CHECK USB 

      Check that "OK" is displayed in USB when USB memory is connected.

      NOTE:

      When USB memory is connected, it takes approximately 2 seconds for audio unit to recognize the USB memory.

      OK: Normal.

      NG: Abnormal. Check the signal line connector. If there are no problems, the unit could be faulty.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.