2013 Subaru Outback Base, Standard TransFACTORY OEM SERVICE PROCEDURE

Stop Light Switch

WARNING: This page is about a different car, the 2013 Subaru Forester. However, it is still accessible from the selected car via links, so may be relevant.
  1. Measure the resistance between stop light switch terminals.
    Fig 1: Measuring Resistance Between Stop Light Switch Terminals
    G05957684Courtesy of SUBARU OF AMERICA, INC.
    Switch position Terminal No. Standard
    When brake pedal is depressed 2 and 3 Less than 1 Ξ©
    When brake pedal is released 1 MΞ© or more
  2. Replace the stop light switch if the inspection result is not within the standard value.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.