2013 Subaru Outback Base, Standard TransFACTORY OEM SERVICE PROCEDURE

Combination Switch (Light): Removal

WARNING: This page is about a different car, the 2013 Subaru Forester. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the ground cable from battery.
  2. Remove the screws and remove the steering column cover lower.
    Fig 1: Locating Steering Column Cover Lower Screw
    G05957752Courtesy of SUBARU OF AMERICA, INC.
  3. Remove the harness cover lock.
  4. Remove the screws and detach the knee protector.
    Fig 2: Locating Knee Protector Screws
    G08542325Courtesy of SUBARU OF AMERICA, INC.
  5. Remove the mounting screws of steering column cover upper.
    Fig 3: Removing Steering Column Cover Upper Screws
    G08542326Courtesy of SUBARU OF AMERICA, INC.
  6. Disconnect the connector from combination switch.
  7. Remove the screws which secure the switch, then remove the combination switch.
    Fig 4: Locating Combination Switch Screws
    G05022457Courtesy of SUBARU OF AMERICA, INC.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.