WARNING: This page is about a different car, the 2013 Subaru Forester. However, it is still accessible from the selected car via links, so may be relevant.

When parts related to the auto headlight beam leveler system are removed or replaced, perform the following procedures to initialize or reinitialize.

NOTE: Before performing initialization or reinitialization, check the following:

Vehicle is parked on a level surface.
The inflation pressure of tires is correct.
Unload any cargo from the vehicle.
Vehicle's fuel tank is fully filled.
Refer to the following chart to determine whether to initialize or reinitialize.

Initialization	When the auto headlight beam leveler control module has been replaced with a new module.
Reinitialization	When the auto headlight beam leveler control module has been replaced with a part from a different vehicle. When suspension parts have been removed or replaced. (Crossmember, front arm, housing, lateral link, strut) When the vehicle height sensor has been replaced or removed.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.

• Brakes feel soft, pull hard to one side, or make grinding noises.

• The engine overheats, stalls repeatedly, or misfires under load.

• You are missing required tools, torque specs, or safe lifting equipment.

• You are not confident in the next step or safety outcome.

Safety Warning

Auto Headlight Beam Leveler System: Procedure: Notes

Use the Manual With the Right Hardware

When to See a Mechanic