Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2013 Subaru Outback Base, Standard TransFACTORY OEM SERVICE PROCEDURE
Steering Angle Sensor: Replacement
WARNING: This page is about a different car, the 2013 Subaru Forester. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
- Do not perform the removal except unless replacing.
- When replacing three times or more, replace by using the combination switch assembly to protect the threads.
- Set the steering wheel in a straight-ahead position.
- Disconnect the ground cable from battery.
- Remove the driver's airbag module.< Refer to
REMOVAL
, Driver's Airbag Module. >CAUTION: Before handling the airbag module, refer to "CAUTION" of "General Description" in "AIRBAG SYSTEM".< Refer to CAUTION , General Description. >
- Remove the steering wheel.< Refer to REMOVAL , Steering Wheel. >
- Remove the screws and remove the steering column lower cover.
- Remove the harness cover lock.
- Remove the screws and detach the knee protector.
- Remove the screws and remove the steering column cover upper.
- Disconnect the connector of roll connector and steering angle sensor.
- Remove the screws which secure the roll connector to steering column.
- Remove the vinyl tape binding the harness, and remove the steering angle sensor from roll connector.
- Turn the protrusion portion of new steering angle sensor to match the alignment mark of inspection hole.CAUTION: Be careful not to allow foreign matter to enter into inspection hole.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
