2013 Subaru Outback Base, Standard TransFACTORY OEM SERVICE PROCEDURE

Section 18 (Brake System): General Description: Caution

WARNING: This page is about a different car, the 2013 Subaru Forester. However, it is still accessible from the selected car via links, so may be relevant.
  • Wear appropriate work clothing, including a cap, protective goggles and protective shoes when performing any work.
  • Before removal, installation or disassembly, be sure to clarify the failure. Avoid unnecessary removal, installation, disassembly and replacement.
  • Use SUBARU genuine grease etc. or equivalent. Do not mix grease etc. of different grades or manufacturers.
  • Before securing a part on a vise, place cushioning material such as wood blocks, aluminum plate, or cloth between the part and the vise.
  • Be sure to tighten fasteners including bolts and nuts to the specified torque.
  • Place shop jacks or rigid racks at the specified points.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.