2013 Subaru Outback Base, Standard TransFACTORY OEM SERVICE PROCEDURE

Torque Converter

WARNING: This page is about a different car, the 2013 Subaru Forester. However, it is still accessible from the selected car via links, so may be relevant.
Model 2.5 L non-turbo 2.5 L turbo
Type Symmetric, 3-element, single stage, 2 phase torque converter
Stall torque ratio 2.05 - 2.35
Nominal diameter mm (in) 246 (9.69)
Stall speed (at sea level) 2, 200 - 2, 700 rpm 2, 800 - 3, 300 rpm
One-way clutch Sprague type one-way clutch
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.