Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2013 Subaru Outback Base, Automatic CVT TransFACTORY OEM SERVICE PROCEDURE
MT Gear Select Cable: Adjustment
NOTE:
Two person are required to perform the MT gear select cable adjustment. (Only the step 7) requires two workers.)
- Loosen the detent bolt of the MT gear shift lever. Refer to ADJUSTMENT .
- Move the shift lever to the 6th.
- Remove the plate cable assembly.
- Disconnect the MT gear select cable.NOTE: Push the MT gear select cable in the direction of arrow, and remove it.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.