2013 Subaru Outback Base, Automatic CVT TransFACTORY OEM SERVICE PROCEDURE

Reduction Driven Gear: Assembly

  1. Using the ST, attach the collar.
    NOTE:
    • Attach the collar in the correct direction.
    • Use a new reduction driven gear COMPL.

    ST 899580100 INSTALLER

    Fig 1: Installing Collar Using Special Tool
    G08317936Courtesy of SUBARU OF AMERICA, INC.
  2. Using the ST, install the parking gear.

    ST 499757002 INSTALLER

    Fig 2: Installing Parking Gear Using Installer
    G08317937Courtesy of SUBARU OF AMERICA, INC.
  3. Using the ST, install the transfer drive gear.

    ST 499757002 INSTALLER

    Fig 3: Installing Transfer Drive Gear Using Installer
    G08317938Courtesy of SUBARU OF AMERICA, INC.
  4. Using the ST, install the ball bearing.
    NOTE: Use a new ball bearing.

    ST 499277100 BUSHING 1-2 INSTALLER

    Fig 4: Installing Ball Bearing Using Special Tool
    G08317939Courtesy of SUBARU OF AMERICA, INC.
  5. Using the ST, counter the rotation of the reduction drive gear assembly, and install the lock nut.
    NOTE: Use a new lock nut.

    ST1 18355AA000 PULLEY WRENCH

    ST2 18334AA000 PIN SET

    ST3 499987003 SOCKET WRENCH (35)

    Tightening torque:Β 

    95 N.m (9.7 kgf-m, 70.1 ft-lb)Β 

    Fig 5: Removing/Installing Lock Nut Using Special Tools
    G08317932Courtesy of SUBARU OF AMERICA, INC.
  6. Crimp the lock nut in 4 locations.
    CAUTION: Do not allow the lock nut to be cracked during crimping operation.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.