2013 Subaru Outback Base, Automatic CVT TransFACTORY OEM SERVICE PROCEDURE

Inhibitor Switch: Removal

  1. Shift the select lever to "N" range.
  2. Disconnect the ground cable from battery.
  3. Lift up the vehicle.
  4. Remove the center exhaust pipe. Refer to REMOVAL .
  5. Remove the snap pin and washer from the shifter arm.
    Fig 1: Identifying Shifter Arm, Snap Pin, Select Cable And Washer
    G08578691Courtesy of SUBARU OF AMERICA, INC.
  6. Remove the spring pin and shifter arm.
    Fig 2: Identifying Spring Pin And Shifter Arm
    G08578692Courtesy of SUBARU OF AMERICA, INC.
  7. Remove the inhibitor harness connector from inhibitor switch.
  8. Remove the two inhibitor switch securing bolts.
    Fig 3: Identifying Inhibitor Switch With Securing Bolts
    G08317792Courtesy of SUBARU OF AMERICA, INC.
  9. Remove the inhibitor switch from the transmission case.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.