Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2013 Subaru Legacy Base, Automatic CVT TransFACTORY OEM SERVICE PROCEDURE
Drive Plate: Installation
- Temporarily install the drive plate and reinforcement drive plate.NOTE: Align the knock pin hole of the crankshaft position sensor plate to the knock pin of the crankshaft to secure the knock pin.
- Set the ST.
ST 498497300 CRANKSHAFT STOPPER
- Tighten the drive plate mounting bolt in two stages.
- Tighten the drive plate mounting bolt.
Tightening torque:
30 N.m (3.1 kgf-m, 22.1 ft-lb)
- While checking the tightening angle with the ST, tighten the drive plate mounting bolts to the specified angle.
Tightening angle:
30° - 35°
ST 18854AA000 ANGLE GAUGE
- Tighten the drive plate mounting bolt.
- Install the transmission assembly to the vehicle. Refer to INSTALLATION .
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
